V-CUT TOOL

Q1: Can the component be bent by 90 degree when 90 degree cutting tip is used?

A1: Yes. It can be bent by standard AFH Tooling (Punch 86 degree, R0.6).

Q2: Can V groove be formed over the full length on sketch blank?

A2: No. Because the range for approach and take-off requires 80mm each.

Q3: What is the maximum V groove depth?

A3: Max.1mm

Q4: Is 30 degree bend OK?

A4: 0 degree and 90 degree only.

Q5: Does the clamp slide during operation?

A5: No. The clamp does not slide within recommended condition.

Q6: Is it easy to exchange the insert?

A6: Yes, by using special allen key that comes with the product.

Q7: Is it possible to perform V-CUT on the upper side of material (Punch side)?

A7: No. V-CUT can not be performed on the upper side of material (Punch side).

Q8: Is it possible to perform V-CUT on vinyl protected materials?

A8: No. V-CUT can not be performed on vinyl protected materials.

Q9: What is necessary other than V-CUT TOOL for V-CUT operation?

A9: V-CUT supported machine , NC(FS31i) and Auto-Pro(since AP100 ver5.20.04) are required.